Gebrauchsanweisung ○ Mode d’emploi ○ Istruzioni per l’uso ○ Instruction for use
o
The iron is now ready-for-use.
STEAM IRONING
o
You can steam-iron using either STEAM JETS or CONTINUOUS STEAM GENERATION.
o
To iron using steam jets, press the steam button (4, Fig. C), exerting more or less
pressure to regulate the desired steam rate.
o
Should you wish to use the maximum steam intensity, completely depress the
steam button. The steam flow will always remain constant, and in proportion to the
pressure you exert.
o
To obtain continuous steam generation, turn the steam regulator (2, Fig. D)
clockwise as shown in the diagram. You thus obtain a uniform and continuous flow
of steam, which is the most intense, when the steam regulator is completely
turned.
o
You can also increase the steam jet during continuous steam generation by pressing
the steam button (4).
o
No matter whether you are ironing using the steam jet function or with continuous
steam, never turn the iron upside down, nor tilt it too far to the fore or side.
o
It must be emphasized that steam is also generated in the automatic mode during
short interruptions in ironing, e.g., when you are preparing the next garment to be
ironed or you briefly switch off the ROTEL STEAMIRONPROFPLUS980CH1. However,
if you take into consideration just how easily steam is generated manually, it is
advisable to avoid automatic steam output, and thereby save energy and steam.
o
You will achieve the best ironing results by categorically turning off the steam
button and, when necessary, trigger a super steam burst by lightly pressing the
steam button. When ironing, NEVER use continuous steam or uninterrupted super
steam bursts the whole time, because your laundry will otherwise become too wet
and the steam supply is exhausted.
o
When setting down the ROTEL STEAMIRONPROFPLUS980CH1
there is a risk of it
slipping!
o
When the water volume has completely evaporated, no more steam will be
emitted.
o
Caution!
Before setting down the iron, always switch off the steam flow. NEVER
OPEN THE SAFETY CAP (1) DURING USAGE. FIRST SET THE SWITCH (7) TO "0"
BEFORE OPENING THE SAFETY CAP. SUBSEQUENTLY, PULL THE POWER PLUG OUT
OF THE SOCKET AND THEN RELEASE THE PRESSURE IN THE IRON BY PRESSING THE
STEAM BUTTON (4).
