Ross TRA-8206, Руководство пользователя

Страница: 22 / 40

3–4 • User Controls TRA-8206 User Manual (Iss. 05)
Output Channel Configuration
A special feature of the TRA-8206 is the ability to operate in a number of different channel
configurations. By simply changing channel jumpers, the TRA-8206 can be configured in the
following ways:
• Single channel
⎯
1:7
• Dual channel
⎯
1:4 + 1:3
• Dual channel
⎯
1:5 + 1:2
• Triple channel
⎯
1:3 + 1:2 + 1:2 (Default setting)
Figure 3.2 Channel Output Jumpers
Channel Rate Selection Buttons and LEDs
Each channel has a channel rate selector button and rate LEDs to set the input signal rate that the
channel will process. Pressing the button illuminates a corresponding LED. Repeated presses will
cycle through the selections.
For most applications, setting the Channel Rate to AUTO (default setting) will allow the
TRA-8206 to automatically detect the incoming data rate. In the AUTO mode, the Data Rate
LEDs will display the data rate detected from the incoming SDI signal.
For applications where only one specific data rate will be used, and the fastest possible lock times
are desired, the TRA-8206 can be set and locked to a specific data rate. Press the
Channel Rate
Selection Button until the AUTO LED is off, and the specific data rate LED is illuminated.
Only SDI signals matching the selected data rate will be reclocked and passed through the
TRA-8206.
Note
—
Position C is not used on the TRA-8206 and should not be selected. The top
empty position for each jumper is for factory use only.