Ross TRA-8206, Руководство пользователя

Страница: 15 / 40

TRA-8206 User Manual (Iss. 05) Installation • 2–3
Installing the TRA-8206
The TRA-8206 is compatible with the DFR-8300 series frames. The procedure for installing the
rear module in your openGear frame is the same regardless of the frame, module, or card used.
Rear Modules for the TRA-8206
The rear module for the TRA-8206 depends on the openGear frame you are installing the card
into.
• DFR-8310 series frames — When installing the TRA-8206 in a DFR-8310 series frame,
the 8310AR-030 Rear Module (R1-8206) is required. The TRA-8206 is also compatible
with the DFR-8310-BNC frames.
• DFR-8321 series frames — When installing the TRA-8206 in a DFR-8321 series frame,
the 8320AR-030 Full Rear Module (R2-8206) is required.
Installing a Rear Module
If you are installing the TRA-8206 in a DFR-8310-BNC frame, or if the rear module is already
present, skip this section.
Use the following procedure to install the rear module in a DFR-8300 series frame:
1. Refer to the DFR-8300 Series User Manual to ensure that the frame is properly
installed according to instructions.
2. Locate the card frame slot on the rear of the frame.
3. Remove the Blank Plate from the rear of the slot you have chosen for card installation.
4. As shown in Figure 2.1 , seat the bottom of the rear module in the seating slot at the base
of the frame’s back plane.
Figure 2.1 Rear Module Installation in a DFR-8310 Series Frame (TRA-8206 not shown)