Ross Opengear FED-6943, Руководство пользователя, Страница: 19 / 92

Fiber Ethernet Switch Transceivers User Manual (Iss. 04) Installation • 2–3
Physical Installation
This section outlines how to install a rear module and a card in an openGear frame. However, the
specific rear module you need to install depends on your application. You must install the Fiber
Ethernet Switch Transceiver in an OG3-FR series frame to take advantage of the internal GigE
interface.
Supported Rear Modules
The rear module that your Fiber Ethernet Switch Transceiver requires depends on the card model.
Refer to the applicable chapter in this manual to learn which rear module is required for your
card.
Installing a Rear Module
If the rear module is already installed, proceed to the section “ Installing a Card ” on page 2-4.
To install a rear module in your openGear frame
1. Locate the card frame slots on the rear of the frame.
2. To apply a label to your rear module:
• Verify whether your Rear Module Label is self-adhesive by checking the back of
the label for a thin wax sheet. You will need to remove this wax sheet before
applying the label in order that the label can be affixed to the rear module surface.
• Affix the supplied Rear Module Label to the BNC area of the rear module.
3. Remove the Blank Plate from the slot you have chosen for the installation.
4. Remove the dust caps from the Fiber ports on the rear module that face the interior of the
frame.
5. Refer to the applicable chapter in this manual to learn which rear module is supported by
your card model.
6. Seat the bottom of the rear module in the Module Seating Slot at the base of the frame’s
back plane. ( Figure 2.2 )
Caution
— Ensure that you install your card using one of the supported rear modules listed
in the applicable chapter of this manual. Installing the card with an unsupported rear module
can damage the card, the rear module, or both.