Ross hyperSPARC, Руководство по установке, Страница: 53 / 66

5-8
5.6 Installing the System Board in the Enclosure
To install or replace the system board in the enclosure:
Caution: Use ESD kit P/N 250-1088 (or equivalent) when installing integrated circuits, printed circuit boards,
and drives in a SPARCserver 600MP. Follow the instructions printed on the ESD mat.
1. Carefully insert the board in the proper slot in the card cage, ensuring that the board does not slip out
of the upper and lower card guides. The component side of the board must face to the right.
2. Ensure that the extraction levers are in the outward position as you slide the board toward the
backplane connectors.
Caution: DO NOT FORCE any board into a slot—you may damage it. The board should insert and seat
smoothly. If it binds, remove the board and inspect the card cage slot for any obvious obstruction. Also inspect
both the board and the backplane for bent pins or other damage. Correct the problems before attempting to
reinsert the board.
3. Press firmly on the board rear panel to seat the board onto the backplane connectors.
The extraction levers should swing into the locked position.
4. Use a 2.5 mm Allen wrench to replace the screws that secure the board to the card cage.
5. Reinstall all cables disconnected in Section 5.2 “Removing the System Board from the Enclosure.”
6. If the system is a 56-inch data cabinet, use a #2 Phillips screwdriver and replace the two screws that
secure the vented rear panel to the enclosure. Then, go to step 7.
If the system is a 12-slot office pedestal, go to step 7.
If the system is a 5-slot office pedestal, replace the top cover:
a. Slide the cover toward the front of the system until the tabs mate with the retaining slots at the
front and rear of the system.
b. Secure the top cover by turning the release knob clockwise one quarter turn until you hear a click.
Go to step 7.
7. Move the system to its normal operation location.
8. Remove and store the wrist strap and the ESD mat.