Ross Carbonite Black, Руководство по установке

Страница: 23 / 56

To Create a Bus Map
All buses and MEs share the same bus map.
1. Press MENU > Config > BusMap .
2. Use the XptBtn knob to select the source button
to assign a video source to.
3. Use the Input knob to select the source to assign
to the selected button on the unshifted bus.
•
<none> — not assigned to a source (cannot
be selected on a bus)
• BK — black
•
XX
— video inputs 1-9
• M X — Media-Store channels 1-2
•
ME X MW — Media-Store video channel used
for MediaWipe effects on ME X (if installed)
• ME
X
MWA
— Media-Store alpha channel used
for MediaWipe effects on ME X (if installed)
• NoSrc — not assigned to a source (can only
be selected on a key bus)
• BG — matte generator
•
PGM — main program output of the switcher
(cannot be selected on an ME)
•
PV — main preview output of the switcher
(cannot be selected on an ME)
• CLN — main clean feed output of the switcher
(cannot be selected on an ME)
• AUX
X
— Aux buses 1-10
• MinME X — MiniME ™ 1-2 program (cannot
be selected on an ME)
•
MM X PV — preview output of MiniME ™ X .
• CK
X — chroma key X .
• CK
X
A — the alpha output of chroma key
X
.
• Shift — access shifted bus
4. Use the Shift knob to select the source to assign
to the selected button on the shifted bus.
To Reset the Bus Map
1. Press MENU > Reset > NEXT > NEXT >
Dfault BusMap .
2. Press the Confrm knob to reset the bus map.
GPI Device Control
You can assign a GPI output to a video source for
basic external device control. When a video source is
taken on-air, the switcher can be set to trigger a GPI
output, with a pre-delay. The external device can be
set up to cue a clip, or load a page when it receives the
GPI input trigger.
To Assign a GPI to a Video Source
1. Press MENU > Config > Input > NEXT >
NEXT
>
NEXT
>
NEXT
.
2.
Use the Input knob to select the video source that
you want to assign a GPI output to.
If you are using the GPI to control the device, the
video source should be the video output coming
from the device.
3. Use the GPO knob to select the GPI output that
you want to assign to the video source.
Note: You must have GPIs set as outputs to be able to
assign them to the video source.
4. Use the Predly knob to select the pre-delay time,
in frames, you want to use with the GPI output.
When you transition a video source with a GPI
assigned to it, and the Roll Clip feature is active,
the switcher triggers the GPI output, and then
waits the pre-delay time before performing the
transition. The length of the pre-delay is usually
the length of time your video server requires to
start playing a clip or your character generator
requires to load a page.
Carbonite Black Setup Manual (v14.0) — Video Input Setup • 23