- 8 -
Heating
When switched on, the red Heat Indicator light will illuminate and the machine will begin to heat up to
its optimal temperature. The initial heating cycle will take 7-10 minutes. When the green Ready Indica-
tor light comes on, the machine is ready to make fog. For optimal performance of the Vapour Plus, it is
recommended that the user wait for the red Heat Indicator to turn off, indicating that the heat exchang-
er has reached its maximum operating temperature, before making fog. Note: If no remote is connected
and no DMX signal is detected, the machine will not heat.
Control Options
There are several methods of controlling the Vapour Plus , including: Manual Control via the Remote
Control Panel, DMX control via a lighting console and Multi-Link control that allows multiple machines
to be controlled from a single Remote Control Panel. The Vapour Plus is designed to process large vol-
umes of fluid over short periods of time. At full output the Vapour Plus will make fog for approximately
60 seconds before stopping to reheat. Longer output durations can be achieved by producing lower fog
output levels.
Manual Control via the Detachable Remote Control Panel that is included with each machine. An op-
erator can control the unit at the machine, or from a distance using the included 3-pin XLR cable. The
Remote Control Panel can be used to set fog output volume, power the machine on and off using Stand-
by mode, and set a repeating, timed cycle of on/off operation.
DMX Control from your lighting desk is available as a standard option. The Vapour Plus will use one
channel of DMX control for output volume.
Multi-Link allows up to 4 machines to be linked together via 3pin XLR cables (not included) and con-
trolled by a single Remote Control Panel.
Using the Remote Control Panel
The Remote Control Panel can be operated directly on the machine or detached from the unit and used
at a distance. To detach the Remote Control Panel from the unit, loosen the thumb screws and lift the
remote from its recessed mount. A 15 foot (4.5m) cable is provided to allow the machine to be operated
at a distance. If needed, a longer 3-pin XLR cable can be used or joined to the existing cable. Do not
exceed a maximum distance of 165 feet (50 m) from remote to machine.
When the green Ready Indicator light is illuminated, the Vapour Plus is ready to make fog. For optimal
performance of the Vapour Plus, it is recommended that the user wait for the red Heat Indicator to turn
off, indicating that the heat exchanger has reached its maximum operating temperature, before making
fog. Press and release the Fog Button to begin producing fog. The red Power Indicator light will flash
to indicate the machine is operating. To stop making fog, press and release the Fog Button again. Adjust
the Fog Level knob to increase or decrease the amount of fog produced.
The Standby Button allows the machine to be “turned off” from the remote without using the Main
Power Switch. In Standby mode, the machine will not reheat or make fog, the pump remains unpowered
and all indicator lights will switch off. To engage Standby mode, press and release the Standby Button.
The red Power Indicator light will turn off. To disengage Standby mode, press and release the Standby
Button again and the red Power Indicator light will turn back on. Once Standby mode is disengaged, the
machine will immediately start heating in preparation to make fog. Note: If no remote is connected and
no DMX signal is detected, the machine will not heat.
Using Timers
The timer controls allow you to set the machine to produce fog in timed intervals without an operator.
To engage the timers, press and release the Timer Button. The green Timer Indicator light will illuminate
and the machine will begin to produce fog at the level set by the Fog Level Knob, and the red Power
Indicator light will flash to indicate the machine is operating.
