- 5 -
Multi-Link Socket
3-Pin XLR socket that allows
for multiple machines to be
daisy chained together and
controlled from a single
Remote Control Panel.
UNPACKING
Your Rosco V-Hazer requires no assembly. Note: 230 volt machines are shipped with bare leads at the end
of the power cord. A proper electrical connector must be attached based on the local power requirements.
Carefully remove the machine from the box. Ensure that no tape or packing materials are stuck to
the machine. Stray packing materials that remain attached to high temperature areas of the machine
could melt or burn during operation. In particular, ensure that the area around the nozzle is free of any
materials or debris.
CONTROLS
Main Power Switch
Turns unit on or off by
controlling the flow of
power to the unit.
Air-Input /
Purge Connection
This is a push-to-connect
inlet that accepts ¼”OD
tubing and allows com-
pressed air to blow through
the heat exchanger for
cleaning and maintenance.
Heat Indicator
A red indicator light that illuminates when
machine is heating in order to achieve
optimal temperature for producing fog.
Fluid Bottle
Ready Indicator
A green indicator light that illuminates when the
minimum temperature for producing fog has been
achieved. Note: All indicator lights will switch off if
Standby mode is engaged.
Removable Remote
DMX-OUT
DMX Panel & Display
Remote Thumb Screws
Loosen to remove
Power Cable
DMX-IN
“Down” Button
Press to decrease the
value of the DMX
address. Press and hold
for faster
decrementing speed.
“Set” Button
Press to store
the DMX address
shown on
the display.
“Up” Button
Press to increase
the value of the DMX
address. Press
and hold for faster
incrementing speed.
