To ensure silent operation when not in use, the fan of the V-Hazer will automatically shut-down after 30
seconds of inactivity. The fan will come back on when the machine begins to produce haze again.
The Standby Button allows the machine to be “turned off” from the remote without using the Main Pow-
er Switch. In Standby mode, the machine will not reheat or make haze, the fan and pump will remain
unpowered and all indicator lights will switch off. To engage Standby mode, press and release the Stand-
by Button. The red Power Indicator light will turn off. To disengage Standby mode, press and release
the Standby Button again and the red Power Indicator light will turn back on. Once Standby mode is
disengaged, the machine will immediately start heating in preparation to make haze. Note: If no remote
is connected and no DMX signal is detected, the machine will not heat.
Using Timers
The timer controls allow you to set the machine to produce haze in timed intervals without an operator.
To engage the timers, press and release the Timer Button. The green Timer Indicator light will illumi-
nate, the machine will begin to produce haze at the level set by the Fog Level Knob, and the red Power
Indicator light will flash to indicate the machine is operating.
Rotate the Fog On Knob to adjust the period of time that the machine will produce haze before
stopping. The numeric settings on the timer knobs are relative settings and do not correspond to
specific seconds or minutes. See the table below for an approximation of the time duration correspond-
ing to each tic on the knob.
Rotate the Fog Off Knob to adjust the period of time that the machine waits before starting to produce
haze again. The numeric settings on the timer knobs are relative settings and do not correspond to specific
seconds or minutes. See the table below for an approximation of the time duration corresponding to each
tic on the knob.
The machine will cycle on and off indefinitely until the Timer Button is turned off. If the Fog Button is pressed
while in Timer mode, this will override any timer settings and the machine will produce haze. When the Fog
Button is disengaged, the timer settings resume, continuing its On/Off cycle as if not interrupted.
Using DMX Control
The V-Hazer can be operated using DMX control from a lighting console or other DMX device. Two chan-
nels of DMX control are required.
Connecting the DMX
Connect the V-Hazer to your DMX chain by inserting a 5-Pin XLR DMX cable into the DMX-IN socket
located on the DMX Panel. A DMX-OUT port allows additional DMX devices to be added to the chain
downstream of the machine. Note: The V-Hazer is not a self-terminating device; a DMX terminator should
be used in the DMX-OUT port when the unit is the last device in the chain.
- 9 -
1 - 4
1 to 4 seconds
4 - 5
4 to 16 seconds
KNOB SETTING
TIMER SETTING
5 - 7
16 to 64 seconds
7 - 9
64 to 250 seconds
