Rosco Laboratories X-Effects, Инструкция по эксплуатации

Страница: 15 / 23

14
Adjusting Brightness
1. Using a small flat screwdriver, turn the adjustment on the
control panel to achieve the desired brightness.
Note: Maximum electronic dimming range is 160-200W
Adjusting Focus
1. Unscrew the face lock ring from the front of the unit.
2. Remove the plastic front cover.
3. Loosen the thumb screw on the lens barrel holding ring.
4. Rotate the lens barrel to adjust the focus.
5. Tighten the thumb screw by hand to hold the lens barrel in
position.
6. Replace the plastic front cover.
7. Replace the face lock ring on the front of the unit.
Note: It is possible for the lens barrel to come in contact with a pattern
while focusing. Do not force the lens barrel if it stops moving or
encounters resistance. Proper rotation of patterns may require the lens
to be backed off a bit.
Adjusting Wheel Speed and Direction
1. The switches on the control panel will select between 3 speed
modes: Off, Slow, and Fast. One is for each wheel.
2. Turn the control panel knobs to fine tune the speed. One is for
each wheel.
3. The potentiometer knobs can be pulled out or pushed in to
change the direction of the wheels.
Adjusting Shutters on the Wheel Module
1. Open the top and bottom hinged lids on the wheel accessory.
2. The top lid gives access to the top shutter.
3. The bottom lid gives access to the bottom and side shutters.
4. Close the top and bottom lids.