Rosco Laboratories X-Effects, Инструкция по эксплуатации

Страница: 12 / 23

11
Installing a Glass Pattern (Wheel Module)
1. Unplug the unit.
2. Unscrew the cover lock ring from the front of the lens module.
3. Remove the plastic cover.
4. Remove the lens module plate from the unit by loosening the
three thumb knobs on the front.
5. Look for the pull tabs on the plates with metal pulleys on either
side. These pull the plates outward for installing new glass
patterns. Once the plate is pulled outward, the pattern should be
inserted such that the metal ring sits in the groove in the rubber
drive pulley and in the 2 plastic idle wheels on the
corresponding side. Once in position, the pull tab can be
released.
6. Replace the lens module plate on the unit by lining up the
mounting pins, then tightening the three thumb screws.
7. Tighten the thumb screw by hand to hold the lens barrel in
position.
8. Replace the plastic front cover.
9. Replace the face lock ring on the front of the unit.
Installing a Lens Barrel (Lens Accessory)
1. Unplug the unit.
2. Unscrew the cover lock ring from the front of the unit.
Pull
Tab
Drive
Pulley
Metal
Ring
Idle
Wheels