Ropox Maxi 2, Руководство пользователя

Страница: 20 / 29

Page 20
Performance test
After installation and prior to use all functions of nursing table must be tested. The
test must be carried out by competent personnel. Subsequently the test shall be
carried out once a year.
Testing prior to connection to mains voltage:
1. Check that mounting instructions have been observed
2. Check that all bolts have been tightened.
3. Check that all cables have been connected correctly and that the plugs have
been pressed home.
4. Check that there is no load on the frame.
5. Check that there is nothing preventing the nursing table from moving freely
within the height adjustment range.
Connect main power to control box and continue testing:
1. Press DOWN button, move frame to bottom position & check movement is
even and controlled. Be aware that hoes connections follow movement of
frame and do not get trapped.
2. Press UPWARDS button, move frame to top position & check movement is
even and controlled. Also, be aware that tabletop does not bump into wall.
Should this be the case it could be because the wall is skewed. If the wall is
only a little skewed (1-2mm) it is possible to adjust by moving the tabletop.
The tabletop is fastened with Velcro. Remove tabletop from Velcro in
opposite side of washbasin and slightly pull away from wall and secure again.
3. If the wall is skewed more that 2mm the lifting unit has to be jacked away
from the wall.
4. Press DOWN on control switch and let frame move 2-5 cm downwards,
activate the safety stop. The frame must stop downwards movement
If all tests are ok, the nursing table is ready for use. See section “Safety in use”.