ROOTS RootsScrub E430, Руководство оператора, Страница: 15 / 19

15
RootsScrub E430
Ÿ
Fill fresh water and detergent as described below before
start of operation.
Ÿ
Fill the fresh water tank with water (50° max) as required by
the work to be done, and add detergent as specified by the
manufacturer.
Use detergents suitable for automatic machines (low foaming) in
order to preclude damages at the suction turbine. We
recommend our agents for cleaning and care, which are
perfectly adopted to the machine. These products fulfil the
requirements of the Detergents Act.
How to operate the machine:
Filling of water
Dirty And Fresh Water Tanks
Ÿ
Turn on Switch “B” the brush is rotating.
Ÿ
To discharge the detergent, position the lever
suitably to achieve the desired flow of
detergent.
Ÿ
Lower the brush head.
Ÿ
Lower the squeegee.
Ÿ
Turn on switch “A” the suction turbine is running.
After lowering the brush move the machine
immediately; otherwise the brush might leave traces on
the floor. Lift the squeegee during reverse travel. When
passing over dormers with a height of more than 0.7° in
=10 mm, the brush drive must be turned off and the
brush must be lifted up.
Ÿ
It is dangerous to pass over the power supply cable while the
brush is rotating.
Ÿ
Cleaning of floor areas starts from the outlet socket and is
effected stripe by stripe.
Ÿ
In case of unoccupied areas it will be useful to clean at first
the border areas, passing with the machine along those areas
in counterclockwise sense.
Ÿ
Cleaning of the remaining areas then should be effected
stripe by stripe, starting from the outlet socket.
Ÿ
Partially occupied areas should be subdivided into single
working areas, within reach of the power supply cable.
Ÿ
Within a short time, the operator will learn how to avoid
unnecessary inconveniences caused by the cable.
When work is completed, the dirty water tank has to be
drained and rinsed.
Draining of fresh water tank
Ÿ
The water level hose is used to drain the fresh water.
The tank requires rinsing at regular intervals.
Fresh water
tank
Strainer
Soiled water
tank
Float switch
The machine has a Dirty water tank and a Fresh water tank. (lye)
Please do not fill water temperature above 50°C. Do not fill the
tank beyond its maximum capacity. Dirty water is fed via the
suction hose into the dirty water tank.
- Do not collect any external water.
- When work is finished both the dirty and the fresh
water tanks on principle must be drained and rinsed
in order to preclude formation of residues.
For disposal of dirty water and lye, the legal provisions
have to be compiled with.
Check the in-feed filter in the tank regularly and clean it
if required.
Procedure for draining tanks
Ÿ
Slowly open the cap and drain the water.
Ÿ
Re-close the cap.
Ÿ
Re-attach the drain hose.
Ÿ
Follow the above sequence to drain the fresh water tank.
Draining of dirty water tank
Ÿ
Is used to drain the dirty water.
PROCEDURE FOR SCRUBBING