ROOTS RootsScrub E430, Руководство оператора, Страница: 13 / 19

13
RootsScrub E430
Brush lifting
Ÿ
Pedal is used to lift and lower the brush.
Ÿ
For lowering, first press the pedal a little to outside (unlock)
and then allow it to move slowly upwards.
Ÿ
For lifting, press the pedal slowly downwards and make it
lock.
Control for the speed of machine
Ÿ
Pull the black knob a little
Ÿ
Take the knob to the left to increase the speed.
Ÿ
Take it to the right to decrease speed.
Ÿ
Leave the knob so that it locks in its place. The speed is
adjustable in four steps.
Brushes/pads
The machine must be equipped with brushes from the
accessories kit, as required by the degree of dirtiness and kind of
ground.
Installation of brush
Ÿ
Press the machine downwards at the rear end
and move to above the brush so that the
catch is positioned, as close as possible, over
the center of the brush.
Ÿ
Lower the front end of the machine so that the catch is
centered in the brush.
Ÿ
Turn on switch “D” for a short time in order to allow locking.
Ÿ
The tank should be empty.
Ÿ
Lift the squeegee.
Ÿ
Place the brush in front of the machine.
Ÿ
Lower the brush head.
When lowering the machine pay attention to prevent
the pedal for lifting of the brush head from being
pressed down.
The brush must snap in immediately. A rattling noise
indicates that the brush head is not correctly centered.
Turn off switch ”D”, correct position of brush head and
turn on switch “C” for locking. Now the brush is locked.
Repeat locking operation.
Removal of brush
Ÿ
Empty the tanks.
Ÿ
Lift the squeegee and the brush head.
Ÿ
Turn on switch “D” for unlocking of brush.
Ÿ
Turn off the machine.
Ÿ
Press the rear end of the machine downwards.
Ÿ
Pull the machine towards the rear side.
Ÿ
Brush is now lying in front of the machine.
2. Speed control lever
1. Pedal for lifting brush
1
2
OPERATION BRUSH