ROOTS RootsScrub E430, Руководство оператора, Страница: 12 / 19

12
RootsScrub E430
4. Close the body back and secure it with screws and rubber
caps. Remove the two tie-bolts outside the body of the
machine .
Screw
Tie bolt
5. Take the machine out of the pallette carefully. Fit the drain
hoses (2 Nos.) ensuring the position of hooked end of the
hoses. Take the power cord through the cable retainer. Now
you can take machine from the platform.
If the supply cord is damaged, it must be replaced by a
special cord available from the manufacturer or an
authorised service agent.
Operating & Indicator Elements:
Controls
1. Adjustable handle
2. Knob - handle
3. Lever for lifting the squeegee
4. Switch to unlock the brush
Control Panel
B
A
1. Switches For Vacuum Motor And Brush
A. ON/OFF switch for Suction Turbine
Ÿ
Is on when “A” is at position “ I “
Ÿ
Is off when “A” is at position “ 0“
B. ON/OFF Switch for Brush Motor
Ÿ
Is on when “B” is at position “ I “
Ÿ
Is off when “B” is at position “ 0“
When, the dirty water tank is full, the float switch will switch Off
the vacuum motor automatically. One, the motor is switched off,
the operator has to switch off the switch ‘A’ and empty the tank.
Ÿ
Brush will be released when switch C is pressed But, ensure
the switch B is at position “ 0 “
C. Switch For Brush Release
2. Cleaning Solution Discharge Control
Ÿ
Turn the lever up, to discharge the detergent and position the
lever suitably to achieve the desired flow of Detergent.
Ÿ
Turn down to close the detergent flow.
Ÿ
Important! Do not over-exert the lever; A gentle force is
enough to close/open.
Lever
0
1
2
3
4
Float switch
1
2
3
4
C
Tie Bolt
INITIAL SETUP
SETUP