ROOTS RootsScrub E430, Руководство оператора, Страница: 11 / 19

11
RootsScrub E430
Comply with instructions for correct dosage of
detergent. Correct dosage will help optimize
costs and also minimize impact on the environment. Too much
foam can affect the performance of the machine.
A squeegee and suitable brushes or pads are required for wet
cleaning of hard floorings. The rotating brush scrubs the floor
thoroughly, removing dirt through suds, thereby cleaning the
floor. The dirty water is drawn during the same cycle through the
squeegee. Thus, the floor can be walked on immediately after it
is dry and clean.
Useful tips:
Ÿ
Prior to wet cleaning, it is necessary to sweep the floor.
Ÿ
This way, not only is the cleaning efficiency improved, but
wear of the brush is also substantially reduced.
Ÿ
If floors are particularly dirty or if wax has to be removed
(basic cleaning); the floor must be treated twice.
Ÿ
During the first cycle, the floor is scrubbed with the cleaning
agent selected according to the degree of dirt encountered,
the squeegee remaining lifted.
Ÿ
Allow the cleaning agent to act on the floor for approx. 5 or
10 minutes, complying with the manufacturer's
instructions.
Ÿ
Scrub the floor once again while the squeegee is lowered.
Ÿ
Too much foam indicates excessive dosage or improper
suitability of detergent for the existing kind of dirt.
Ÿ
Detergent particles contained in the soiled water that are
not used will cause formation of foam.
Ÿ
Instructions for dosage are given on the detergent tank and
must ideally adhere to manufacturer's recommendations.
Ÿ
The ideal type of detergent and the perfect dosage
applicable to it will come through sustained use of the
machine.
After unpacking:
Principle of Operation
Before operation:
1. Upon delivery, the machine has been secured by insulations
blocks and hooks at the bottom to preclude unwanted
movement of the machine. After taking the machine from the
pallet:
Ÿ
Open the cardboard box at the top side and pull upwards to
remove it.
Ÿ
Remove the hook by loosening the screws.
Ÿ
Lift the brush head to up position by using pedal.
Ÿ
Take the machine off the box and avoid any damage to the
machine.
Ÿ
Remove the nut from the plank in order to remove the brush
from the pallet.
Qualified personnel only are admitted to open the
machine; Any work such as e.g. maintenance or repair
actions at the electric components have tobe executed
with adequate tools only and by qualified personnel
only.
2. Tilt the body of the machine to gain access to the inside of the
tank, the tank will stay in its position with a help of a rope assy.
- Care should be taken while closing the tank.
-Do not drop hardly, which might cause possible damage
to equipment and cause personal injury.
3. The brush motor is fastened to the connecting arm for upward
and downward movement of brush head and this can be
controlled by the pedal. In order to prevent unwanted
swinging movement during transport, stopper pin in the
connecting arm hits the bolt of the brush head to retain its
stability. Also remove the tie bolt indicated in the picture.
Verify the machine and accessories with the invoice copy. Check
the machine for any transit damage, if found contact the
branch/dealer immediately.
Owner’s personnel are not allowed to
unpack the machine.
Rubber cap
& screw
INITIAL SETUP
SETUP