Assembly Instructions
Round-Top Walk-In Coop
Model 2 V1 2022
Copyright ® Roost & Root all rights reserved.
Step 2D - Upper
Roost Roof
Page
35
Push
Panels up
Tight
Before
Screwing
Down
Push the TB top back panel up against the side of the coop (C2 panels) and align the pre-drilled holes along the right edge
up with the center of the roost back wall, G2 Panel. Loosely screw in upper right corner.
G2
C2
Push the TF top front panel up against the side of the coop (C2 panels) align the pre-drilled holes along the right edge up
with the center of the roost front wall, G1 panel and overlap V-Grooves on the TB panel. Loosely screw in upper left corner.
Using your drill and the small provided bit, drill through both pieces of roof metal at the indicated positions trying not to
drill too deep into the tops of the G12 supports. Double check the alignment of panels and while pushing
up against the C2 panels, screw down the remaining
3 spots on the top edge.
Roof
Screw
Tighten only enough to compress
rubber washer.
1
2
1
2
3
3
TF
TB
