Romus sandy 2 CM33-43 F, Руководство по эксплуатации и обслуживанию, Страница: 11 / 22

ROMUS - Z.A. Les Pouards, 13 et 15 rue Taillefer 91160 CHAMPLAN – FRANCE
10
WORK
11. PREPARING TO WORK
1. Make sure the power supply cable is not damaged.
2. Plug the power supply cable of the machine into the mains socket.
3. Bring the handlebar to the work position by acting on the release lever.
12. MANOEUVRABILITY OF THE MACHINE
The first time an operator uses the machine, he/she should become familiar with the movements to be
imparted to the shaft in order to be confident enough with the directionality of movement of the machine,
and should therefore not operate the machine near people or obstacles.
Work in slow movements to the right and left, possibly moving back so that the operator always stands on
an area of the floor yet to be cleaned up.
Keep the power supply cable behind the operator, taking care not to operate the machine in its vicinity in
order not to damage it.
Do not insist too much on the same area so as to avoid damaging the floor, also in function of the type of
brush or abrasive floor pad chosen.
In operation, the machine moves to the right by slightly lifting the handlebars.
In operation, the machine moves to the left by slightly lowering the handlebars.
13. WORK
1. At this point, by pressing the dead man's lever (1) and activating the main switch control lever (2), the
machine can operate at full efficiency.
2. Let the machine run on dry for a few seconds (optional solution tank kit).
3. Apply a small amount of detergent solution to the floor by pressing the lever (3) until the brush is
saturated with foam (optional solution tank kit).