Romus sandy 2 CM33-43 F, Руководство по эксплуатации и обслуживанию, Страница: 10 / 22

ROMUS - Z.A. Les Pouards, 13 et 15 rue Taillefer 91160 CHAMPLAN – FRANCE
9
MACHINE PREPARATION
6. Insert the water distribution pipe (4) in the hole on the brush head (5).
9. DETERGENT SOLUTION
Fill the solution tank only when the column is in vertical position, by proceeding as follows:
1.
Fill it with clean water at a temperature not exceeding 50

C.
2. Add the liquid detergent to the tank in the concentration and manner indicated on the detergent
manufacturer's label. The formation of excess foam could damage the internal components of the
machine, so only use the minimum amount of detergent needed.
WARNING: you are advised to always wear protective gloves, to avoid the risk of
serious injury to your hands
WARNING: We recommend that you vacuum at intervals the dirt-loaded foam with a
vacuum cleaner for liquids.
10. ASSEMBLING THE BRUSH
To insert the brush:
1.
Plug the power supply cable into the mains socket.
2. Place the brush in front of the brush head unit.
3. Raise the brush head by using the handlebar as a lever.
4. Position the brush head above the brush.
5. Activate the handlebar tilt lever.
6. Press the dead man's lever and pulse-press the main switch control lever to insert the brush in the
brush head.
WARNING: you are advised to always wear protective gloves, to avoid the risk of
serious injury to your hands
WARNING: during this operation, check there are no people or objects near the
brush.
WARNING: Make sure the brushes are correctly connected. If this is not the case,
the machine could move in an irregular, sudden manner.