K. Take a Measurement
1. Press the key “ ”. All digits will light up, checking the
display functions. The checking process will be completed
after about 2 seconds.
2. After all symbols appear, the display will show a blinking
“0”. The monitor is now ready to measure and will
automatically inflate to a settled pressure value around
180mmHg. This monitor will re-inflate automatically to
approximately 210mmHg, if the system detects your body
needs more pressure to take the measurement.
3. After inflating to the settled pressure, the device starts to
deflate, when the heartbeat was detected, a heart symbol “
” will blinking on the display. The blinking “ ” mark
blinks with each heartbeat.
4. When the measurement is completed, the cuff will
deflate automatically. Systolic, diastolic and pulse with
date/time will be shown simultaneously on the LCD
screen. The measurement results will be stored
automatically. If a mistake was detected during the
measurement, the symbol ‘E’ will display on the screen.
Please refer to troubleshooting on page 16.
5. Press the key “ ” to switches off the device. Untie the cuff and pack the
device in the box to preserve the device.
Note:
This monitor will automatically switch off after 3 minutes.
To stop the measurement procedure, please press the key “ ” directly.
11
