troUBLE SHootInG GUIDE
problem
Solution
Leaking
1. Check the internal gap between the Bath and the Wall Profile has been sealed correctly.
2. Ensure the Bath is fully sealed along the tiled walls prior to installation.
3. If the Fixed Panel is sealed on the inside along the Bath top, this will cause leakage -
sealant must be removed.
4. Ensure the Wall Profile on the tiled wall is sealed both vertically inside and outside.
5. Is the Wall Profile fitted where it was marked during the dry fit.
6. Ensure the deflector on the Bottom Seal is facing inward towards the Bath.
7. Check that the bath is compatible with the bath screen I.e. Flat top bath,Non sculptured
bath and no hand rails.
Important: this enclosure should be water tested conforming to BS En 14428
Folding Bath Screen
alignment on Bath
1. Is the Bath Screen fitted onto a tiled wall?
2. Is the Wall Profile fitted where it was marked during the dry fit.
3. Is the Wall Profile completely vertical?
4. Has the Bracing been fitted, are all the screws tightened.
Some important information to help you Maintain your product.
The following information is all you need to keep your product looking new.
Clean your product using a mild detergent diluted in water and then polished off using a soft cloth.
If you live in a hard water area, periodically clean your product using a 50/50 solution of white vinegar and water. The
solution should be left on the enclosure for approximately 5 minutes then rinsed off using warm water. This method of
cleaning should remove lime scale residue.
Simple Maintenance
Our products are generally maintenance free, however it may be necessary to lubricate wheel assemblies and other
moving parts from time to time.
It is strongly recommended that a quality silicone spray is used.
a list of Dont’s:
1. Don’t use acidic based products which are unsuitable for cleaning enamel surfaces.
2. Don’t use abrasive cleaners or cleaners using bleach or solvents, these products will adversely affect the finish of
the aluminium profiles.
3. Don’t use scouring pads, powder or any sharp instruments when cleaning the enclosure.
Should you experience any problems during installation please refer to the
Trouble Shooting Guide or contact Customer Relations on:
+44 (0) 1325 328033
To enable customer relations to provide you with an excellent level of service it is important that you
quote your product Code and Reference Number - these can be found on the Guarantee card.
