-
Never place the device near a wall or near a partition makes of combustible materials
even if it is very well isolated.
-
A distance of minimum 10 cm with the partition or the wall is necessary.
b) First starting
:
Before the first use, remove the anti
-
corrosion protection fat with a cleaner and a wet
sponge.
During the first use, grease your plate with oil and preheat the crepe machine during
about 15 min. Once preheating is finished, set the thermostat on the wished tempera-
ture.
First cleaning
Clean the device before the first use. (See 6. Cleaning)
Connection of the device
-
Check that the tension and the frequency of the electricity network suit to the values
indicated on the descriptive plate.
-
Make sure that every control knob is positioned on 0.
-
Check that neither the cord nor the plug are damaged
-
Unwind completely the electric power cable and connect it in a plug connected with
the earth.
-
The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly on
the electricity network, confide its connection to a qualified person .
c) Use of device
:
Elements of command and display
Putting on
Turn on the thermostat control knob (n°2 on picture) on the wished position: the
green pilot light (n°1 on picture) ignites: the machine is on. And the orange pilot
light (n°3 on picture) ignites. The machine is warming up. Once orange pilot light
(n°3 on picture) is off, the machine reached the wished temperature. Grease the
plate before each cooking.
Command/Display
Function
Thermostat (n°2 on picture)
On/off + Temperature setting
Orange pilot light
(n°3 on picture)
Machine is heating (pilot light on)
Temperature reached (pilot light off)
Green pilot light (n°1 on pic-
ture)
Machine is on (pilot on)
Machine is off (pilot off)
14
