Installation
EVQROCM-01-V03-R0 Installation and Operation Manual
Quantum:EV OpenCharge
January 2022
Page
16
of
25
Install the Pedestal
IMPORTANT:
All electrical work must be performed in accordance with the current
Electrical Wiring Regulations applicable in the geographical region of the installation.
CAUTION: Equipment Damage
Do NOT use power tools to remove/install panel fixings.
Power tools can damage the fixings, making the panel difficult to remove.
Use hand tools ONLY and do not overtighten fasteners.
CAUTION: Equipment Damage
During the next steps the charger front panel will be removed. Take care to not
damage cables or components.
1. Remove and retain the fixings securing the front panel to the pedestal chassis.
2. Carefully ease the
front
panel away from the unit to gain access to the interior.
CAUTION: Equipment Damage
Fascia panels may be connected to the main assembly by electrical cables. Take
care not to damage, strain, or disconnect the cables. Make sure all connections are
secure before refitting the panel.
3. If required, cut ‘X’ shaped slits in the rubber splash mat to match the mounting
points of the base and to allow entry of the power and ethernet cable (if required).
4. Fit the mat over the cables and onto the ground mounting base or the securing
points if a base was not supplied.
5. Carefully lift the pedestal then lower the chassis over the cables and onto either:
x
the ground mounting base (align the four holes in the chassis with the four studs
of the base).
x
the prepared surface.
6. Route the cables to the appropriate length to be able to connect to the terminals
within the chassis.
7. Secure the chassis to the ground with the correct fixings for the location.
8. Trim around the pedestal base to remove any excess rubber from the splash mat (if
required).
NOTE:
All electrical work must be performed in accordance with the current
legislation applicable in the geographical region of the installation.
CAUTION; Equipment Damage – Sensitive Equipment
If you will be performing insulation resistance tests on the power supply cables, it is
advised to be done BEFORE connecting the cable to the charger. The high voltages
applied during the test may damage sensitive components if tested after the cable is
connected.
9. Terminate the supply cable in the appropriate manner and connect to the
pedestal in accordance with the appropriate schematic.
10. If required, connect the Ethernet cable to the Communications unit.
Содержание OCPP0410
Страница 27: ......