Roland V-Drums TD-12KX, Руководство пользователя

Страница: 9 / 16

9
When adjusting, use the drum key supplied with the VH-11.
• On the PD-105, adjusting the head tension affects only the
head response, and does not change the pitch of the sound,
as it would on an acoustic drum.
• The head tension will change as the instrument is used, so
you should readjust when necessary.
• The head stretches when used for extended periods, so even
when this is adjusted in the following procedure, you may
not achieve the same degree of tension as when the head
was initially adjusted. Strike the head to check the feel and
response as you adjust the tension.
1.
Loosen the tuning bolts until a slight gap is
produced.
2.
Tighten all tuning bolts by fingers, as tightly as you
can.
3.
Using the drum key, turn the tuning bolts two full
revolutions each, thus tightening them.
Tighten each tuning bolt one by one, observing the
numerical order shown in the figure.
When attaching the PD-105 to the mount, be sure to
tighten the stand fixing screw securely. If it remains
loose, the pad could fall off.
PD-105
(V-Pad)
Adjusting the Head Tension
Hoop (Rim)
Lugs
Output Jack
Shell
Bracket
Frame
Head
Stand Fixing
Screw
Tuning Bolts
Be sure to adjust the head tension before use.
In general, a tension that produces a strike response
approximately the same as an acoustic drum will be
appropriate.
• Striking the head when the head tension is loose
may damage the sensor and head.
• Should you neglect to make the appropriate
settings, you could likely experience the following
problems:
Sometimes it does not sound (uneven volume).
The volume is too low (reduced sensitivity).
Attaching the Pad to a Stand
Tuning bolt
Hoop
Washer
Slight gap
1 3
4
2
5
6
HEAD MADE BY REMO U.S.A.
Rod
tighten loosen
TD-12KX_e.fm 9 ページ ２００９年１１月１０日 火曜日 午後１２時６分