11
fig.PD-85-Set.e
When attaching the PD-85 to the mount, be sure to
tighten the stand fixing screw securely. If it remains
loose, the pad could fall off.
When the Head Should Be Replaced
The head is an expendable item that eventually will wear out
and need to be replaced. Replace the head when the
following occurs:
• The head surface is torn
• Striking points are no longer detected correctly, even when
the head tension is properly adjusted.
• Slack portions remain in the head even after the head tension
is properly adjusted.
1.
Remove all tuning bolts and washers.
* Press the lock bushing (in figure below) in place with your
finger as you remove each tuning bolt, to prevent the
bushings from being pulled off the frame.
fig.PD-85-Head3.e
* The lock bushings prevent rotation and loosening of the
tuning bolts caused by vibrations that are transmitted from
the hoop as you play.
2.
Remove the hoop.
3.
Remove the old head.
4.
Place the new head on the frame.
5.
Place the hoop onto the head.
6.
Pass the tuning bolts through the washers, then
attach them to the hoop and frame.
7.
Next, adjust the tension of the head (p.10).
* Fully tightening a tuning bolt at only a single location
produces uneven tensioning, which may make it impossible
to obtain the proper strike sensitivity and may even result in
incorrect operation. Be sure to tighten each tuning bolt a
little at a time, as described in the above explanation.
If a lock bushing happens to become separated from
the frame while the head is being replaced, position the
bushing so its four slots are aligned with the
corresponding ridges in the frame, then press down
firmly on the bushing.
fig.LockBush.e
Attaching the Pad to a Stand
Replacing the Head
Rod
Pass the rod through the pipe
that is inside the holder.
Tighten
Loosen
Drum Key
Hoop
Hoop’s
Rubber Portion
Lock Bushing
Washer
Loosen
Tighten
Frame
Tuning Bolt
Lock Bushing
Frame
TD-12KX_e.fm 11 ページ 2009年11月10日 火曜日 午後12時6分
Содержание V-Drums TD-12KX
Страница 1: ...Owner s Manual TD 12KX_e fm 1...