Roland SJ-540, Руководство пользователя

Страница: 52 / 102

50 Chapter 3 - A Wide Variety of Operations
3-3 Setting the Location Where Printing Starts
Specifying a Location in the Scan Direction
1
Press the [ ] key to move the printing car-
riage to the present starting location for print-
ing in the scan direction.
2
Use the [ ] and [ ] keys to move the marker
to the new print-start position.
The printable width appears on the display.
3
Press the [BASE POINT] key.
4
Press the [ENTER] key.
The printing carriage moves to the standby position.
Right-hand edge
of the media
The BASE POINT LED lights up
Marker
If the printing carriage moves away from the
standby position when not printing, problems such
as drying-out of the printing heads or dot drop-out
during printing may occur. For this reason, about
60 seconds after pressing the [
] key to move the
printing carriage, the printing carriage returns to
the standby position.
Also, the printing carriage returns to the standby
position when about 30 seconds passes during this
interval after the [
] and [ ] key is released. If
the setting could not be made in within the time
limit, then do the setting over again from the be-
ginning.
Canceling the Setting
A position set using [BASE POINT] key is canceled in situations like the following.
• When one page was printed
• When media setup is canceled by pressing the [SETUP] key
W 1234 mm
Top menu
Starting location for printing
in the scan direction