background image

4

**RPN**

F-50 can transmit Master fine tuning (RPN #1) and RPN null. After sending the master fine
tune, immediately the RPN Null shall be sent.

RPN

Data entry

MSB LSB

MSB LSB

Explanation

00H 01H

mmH llH

Master Fine Tuning
mm, ll: 00 00H - 40 00H - 7F 7FH (-100 - 0 - +99.9 cents)

7FH 7FH

--- ---

RPN null

Program Change

Status

2nd byte

CnH

ppH

n = MIDI channel number:

0H-FH (ch.1-ch.16)

pp = Program number:

00H..40H (prog.1..prog.65)

*

For the correspondence between Program Change numbers and Tones, please refer to 
“Program Change” in “1. Receive Data.”

System Realtime Message

Active sensing

Status
FEH

*

This will be transmitted constantly at intervals of approximately 210 msec.

System exclusive messages

“Identity Reply” and “Data Set 1 (DT1)” are the only System Exclusive messages
transmitted by F-50.
The exclusive message of F-50 data has a model ID of 1AH, and device ID is defined by
MIDI UNIT NUMBER.
UNIT NUMBER is always the same as the current MIDI Tx/Rx channel.

Universal Non-realtime System Exclusive Messages

 

Identity Reply

Status

Data byte

Status

F0H

7EH, dev, 06H, 02H, 41H, 1AH, 00H, 06H, 02H, 02H, 01H, 00H, 00H

F7H

Byte

Explanation

F0H

Exclusive status

7EH

ID number (universal non-realtime message)

dev

Device ID (dev: UNIT#-1)

06H

Sub ID#1 (General Information)

02H

Sub ID#2 (Identity Reply)

41H

ID number (Roland)

1AH

Device family code (LSB)

00H

Device family code (MSB)

06H

Device family number code (LSB)

02H

Device family number code (MSB)

02H,01H,00H,00H

Software revision level

F7H

EOX (End of Exclusive)

*

When Identity Request is received, Identity Reply message will be transmitted.

Data transmission

Data set 1 DT1

Status

Data byte

Status

F0H

41H, dev, 1AH, 12H, aaH, bbH, ddH, sum

F7H

Byte

Explanation

F0H

Exclusive status

41H

ID number (Roland)

dev

Device ID (dev: UNIT#-1)

1AH

Model ID (F-50)

12H

Command ID (DT1)

aaH

Address MSB: upper byte of the starting address of the data to be sent

bbH

Address LSB: lower byte of the starting address of the data to be sent.

ddH

Data: the actual data to be sent.

sum

Checksum

F7H

EOX (End Of Exclusive)

*

Regarding the address please refer to section 3 (Parameter Address Map).

*

Regarding the checksum please refer to section 4 (Supplementary material).

Section 3. Parameter Address Map 
(Model ID = 1AH)

All the numbers of address, size, Data, and Default Value are indicated in 7-bit
Hexadecimal-form.

 

+————————————+—————————+————————————————————————————————————————+
| address(H) | data(H) | Description                            |
|————————————+—————————+————————————————————————————————————————|
|   01 03    |  00—7F  | Reverb Type                            |
|            |         |    00H — 0FH : Type 1                  |
|            |         |    10H — 1FH : Type 2                  |
|            |         |    20H — 2FH : Type 3                  |
|            |         |    30H — 3FH : Type 4                  |
|            |         |    40H — 4FH : Type 5                  |
|            |         |    50H — 5FH : Type 6                  |
|            |         |    60H — 6FH : Type 7                  |
|            |         |    70H — 7FH : Type 8                  |
+———————————————————————————————————————————————————————————————+

Содержание F-50






Отзывы: