Roland Edirol M-16DX, Руководство пользователя

Страница: 14 / 60

14
Names of things and what they do
fig.Cpanel-2
11. MUTE (ALT) Switches
Determine whether the signal of the channel will be sent to the
ALT bus or to the MAIN bus.
* If a channel is being sent to the ALT bus, its channel number is
highlighted in the level meter screen.
fig.02-MUTE-ALT
12. INSERT FX Switch (channels 1, 2)
When the insert effect is on (INSERT FX button lit), these
switches determine whether the insert effect will be used for
channels 1 and 2, respectively.
If a switch is on ( ), the insert effect will be applied to the
input signal.
13. Channel LEVEL Knobs
Adjust the levels of the signals input to the channels.
* In order to reduce the amount of noise in your mix, channels
you’re not using should be set to the minimum level.
14. DIGITAL Button (channels 11/12)
Specifies whether the signal from the LINE IN jacks or the
signal from DIGITAL IN (jack/connector) is to be input to
channels 11/12.
The sampling frequency at which the mixer operates will
automatically switch to the sampling frequency of the digital
signal that is being input at DIGITAL IN (jack/connector), and
will synchronize completely to this sampling frequency.
* The current sampling frequency is shown in the utility screen (p.
44).
15. USB Button (channels 13/14)
Use this when you want to input signals from USB connector
into channels 13/14.
11
13
12 14
15
On ( )
The signal of the channel will be sent to the
ALT bus, and muted for the MAIN bus.
Off ( )
The signal of the channel will be sent to the
MAIN bus.
Button lit
When you press the DIGITAL button,
the button will light if a valid digital
signal is being input to DIGITAL IN
(jack/connector), and the signal from
DIGITAL IN (jack/connector) will be
input to channels 11/12.
Button blinking
If no digital signal is being input, or if
its sampling frequency is not support-
ed by the M-16DX, the button will
blink, and the signal from the LINE IN
jacks will be input to channels 11/12.
Button unlit
The signal from the LINE IN jacks will
be input to channels 11/12.
Button lit
If the USB connection is valid, the button
will light automatically, and the signal
from USB will be input to channels 13/14.
Button unlit
Only the signals from LINE IN will be input
to channels 13/14.
Caution when using a USB connection
* You can’t change the sampling frequency while the M-16DX
is connected via USB.
If the mixer’s operating sampling frequency is different
than the sampling frequency of the digital signal being
input to DIGITAL IN (jack/connector) when you press
the DIGITAL button, the button will blink, and the input
to channels 11/12 will switch to the signal from the LINE
IN jacks.
In this case, you can either select the appropriate
sampling frequency on the digital device that’s
connected, or temporarily disconnect the USB cable and
then reconnect it after the button has changed to steadily
lit.