Roland Edirol M-16DX, Руководство пользователя

Страница: 12 / 60

12
Names of things and what they do
fig.Cpanel-1
1. LO CUT Switches
Switch on/off the low cut filters.
When a switch is pressed ( ), the low-cut filter is turned
on, and the range of frequencies below 75 Hz are cut.
Use this to eliminate unwanted low-frequency noise.
2. SENS Knobs (channels 1–4)
Allow you to adjust the sensitivity as appropriate for the level
of the input signal.
If you’re using the MIC connector, you can change the setting
of the function switch to further specify the range of
adjustment.
➝
“Switching the adjustment range of the SENS knobs
(SENS RANGE)” (p. 44)
* If this is set to NARROW, you’ll be able to make detailed
adjustments.
When you turn the SENS knob, it may seem as though the
change does not occur smoothly, but this is not a malfunction.
3. EQ Knobs (HI, MID, LOW)
Provide for three-band equalization, with high, mid, and low
frequency controls for each channel.
The corresponding frequency range will be boosted when you
turn a knob toward the right, be cut when you turn it toward
the left, and made flat when the knob is in the center (U)
position.
When you turn a knob, the equalizer screen will appear in the
display, showing the current settings both numerically and
graphically.
fig.02-EQ.bmp
Mix controller
Channel control section
1
2
3
5
6
9
10
4
7
8
Connector Range of adjustment
MIC connector (XLR) +10– +60 dB
LINE IN jack (TRS) +10– -40 dBu