Roland Color Camm Pro PC-60, Заметки по обслуживанию

Страница: 48 / 100

44
4 Adjustment
4
SERIAL INTERFACE CHECK
Turn on the SUB POWER SW
by pressing [ ] key.
Push [CUT TEST] to check again,
turn off the SUB POWER SW to end.
Connect the Loop-Back
Connector to serial port.
OK NG
RS-422 [PIECE] LED : ON [PIECE] LED : BLINK
RS-232C [ROLL] LED : ON [ROLL] LED : BLINK
RS-422 CABLE CONNECTION
RS-232C CABLE CONNECTION
TEST PATTERN MODE
Turn on the SUB POWERSW by pressing
[ ], [ ] and [CUT TEST] keys.
Select Test Pattern by pressing
[BASE POINT] or [CUT TEST] keys.
Set the Black Ribbon and Media.
Lower the Sheet Loading Lever to print.
Turn off the sub power SW to end.
Connection
2 (TxD) 3 (RxD)
5 (CTS) 20 (DTR)
Connection
1 (HskoA (DTR)) 2 (HskiA (/CTS))
3 (TXDA-) 5 (RXDA-)
6 (TXDA+) 8 (RXDA+)
TEST PATTERN CARTRIDGE HOLDER LED
NO.1 NO.2 NO.3 NO.4 NO.5 NO.6
3mm pitch straight line
OFF OFF OFF OFF OFF OFF
Dithering Test Pattern ON OFF OFF OFF OFF OFF
100% Dithering Pattern OFF ON OFF OFF OFF OFF
Slanting Parallel Line ON ON OFF OFF OFF OFF
Solid Color Test Pattern with
bottom half of Head
ON OFF ON OFF OFF OFF
Solid Color Test Pattern with
top half of Head
OFF ON ON OFF OFF OFF
Checker ON ON ON OFF OFF OFF