Roland CAMM SCRIBE CS-20, Руководство пользователя

Страница: 23 / 28

15
9 Maintenance
These are maintenance tasks that should be performed
by the user.
Use a vacuum cleaner to remove cutting dust.
Do not use any blower like airbrush. Otherwise, dust spread in the air may harm your health or damage
this machine.
Cleaning the Unit
Replacing the Bearing for the Depth Regulator Nose (Option: DRN-20)
Replacement of spindle belt
Like the motor, the belt is a part that wears out.
As a guideline, the spindle belt should be replaced after every 2000 hours of use.
Replacement of spindle motor
The spindle motor is a part that will eventually wear out. After extended use, strange noises may be heard from the motor,
or the motor may fail to turn.
As a guideline, the spindle motor should be replaced after every 2000 hours of use.
Recommended Service Checking
Please be aware that the following maintenance tasks are charged, even when performed within the unit's warranty period.
How to Remove
the Bearing
How to Install
the Bearing
Bearing for
Depth regulator nose
3 mm (1/8")
Screw on the bearing for
the depth regulator nose
until this space is
approximately 3 mm (1/8").
When engraving is performed, cuttings may get inside the bearing, resulting in a strange noise.
Because this can also degrade the quality of engraving, replacement of the bearing after every 100 hours of engraving is recom-
mended. (New bearings can be purchased from your vendor.)
Use a dry cloth to clean the unit.
When engraving has been performed, use a whisk broom
or a vacuum cleaner to clean up any cuttings.
When cleaning the CAMM SCRIBE, make sure that the
main unit's power OFF.