Roland CAMM SCRIBE CS-20, Руководство пользователя

Страница: 18 / 28

10
For the Scoring (Diamond scraper)
* Use SELECT key to choose "PEN (SCORE)" as the mode.
3
4
1
2
When performing scoring, be sure to purchase the diamond scraper (optionally available).
Tighten the screw securely to secure the tool in
place.
* If the depth regulator nose is
installed, it should be removed.
Loosen the screw for the engraving-tool holder and
lower the blade of the diamond scraper until it
protrudes about 1 mm (1/16") from the tip of the
adapter.
Loosen the tool mounting screw and insert the
special adapter into the tool carriage.
Hexagonal
screw driver
Engraving-
tool holder
1. Turn in the
direction of the
arrow to tighten
provisionally.
2. Rotate in the direction
of the arrow.
1 mm (1/16")
Hexagonal
screw driver
Hexagonal
screw driver
Retighten the tool mounting
screw to secure in place.
Provisionally tighten the diamond scraper in the
engraving-tool holder, and insert it into the tool
carriage.
* If the depth regulator nose is
installed, it should be removed.
Retighten the tool mounting
screw to secure in place.
3
Loosen the tool mounting screw and insert the tool
adapter into the tool carriage.
< Example >
* If the sheet is to be applied to a hard material such as glass
or an acrylic panel, it is possible to eliminate the transfer
step and enable smaller characters to be cut by affixing the
sheet to the material first, before cutting.
1. Prepare the sheet to be cut.
2. Prepare the rigid material (acrylic panel, glass panel,
etc.).
3. Peel off the backing paper from the sheet and affix the
sheet to the rigid material.
4. Use double-sided tape or the like to secure the rigid
material with the affixed sheet to the table.
5. Perform cutting.
6. Peel off the unneeded portions.