Roland CAMM SCRIBE CS-20, Руководство пользователя

Страница: 20 / 28

12
Test Cutting
1
The CAMM SCRIBE can perform test cutting to check whether cutting conditions are correct. Test cutting is also recommended
to determine optimal cutting conditions such as the compatibility of the material and tool, as well as cutting speed.
I f the results of test cutting are less than satisfactory, refer to " About Tools and Materials" and " Setting Cutting Conditions"
and redo the settings.
It may be a good idea to use a blank area of a piece of material or an extra scrap for test cutting.
Setting Cutting Conditions
Changing the Offset Value... ( Only When Performing Cutting )
When performing cutting, make sure that an appropriate value has been set for the offset.
When using the blade for vinyl films that comes with the CAMM SCRIBE, set the offset value to 0.25 mm (0.00984").
(The offset is set to 0.25 mm (0.00984") when the CAMM SCRIBE is shipped from the factory.)
2
Check again to make sure that the correct material and tool for the select mode have been loaded and installed.
3
4
Required Area
Hold down the
SET SURFACE / TEST
key for
one second or more.
Test cutting starts.
Use the SELECT key to choose the cutting or plotting
mode.
Cutting
25 x 25 mm (1" x 1" )
Engraving, Plotting
15 x 15 mm (5/8" x 5/8" )
The LED for the selected mode lights up.
Offset too small Offset too large
3
2
1
Correct offset value
Corners are rounded Corners are attractively cut Corners have "horns"
Use SELECT key to choose " CUTTER " as the mode.
Press the PAUSE key.
Hold down the key for two seconds or more to change the offset value to 0.75 mm (0.0295"), or hold down the
key for two seconds or more to change it to 0.25 mm (0.00984").
The LED for the SELECT key's CUTTER mode flashes, and the setting is made.