14
7 Sending Cutting and Plotting Data
Cutting and plotting is performed when data is sent from the computer (software application).
Refer to the manual for the software and drivers you are using for an explanation of how to output cutting and plotting data.
Changes That Can Be Made While Cutting and Plotting
PAUSE . . . . . . .
Pressing the
PAUSE/VIEW
key causes operation to pause, even when cutting and plotting is in
progress.
Press the
PAUSE/VIEW
key a second time to continue cutting and plotting.
Pausing Operation
If engraving was performed, vacuum up any cuttings.
Close the software application and switch off the computer.
Switch off the power to the CAMM SCRIBE.
Remove the tool and put it away.
• If the day's operations are finished, remove the blade, tool adapter, and depth regulator nose.
Use a dry cloth to wipe away any grime, cap the blade, and put it away.
• To keep pens from drying out, they should be capped when operations are finished.
Move the tool carriage to the inner-right area of the table, make sure operation is stopped, then remove the material.
• If the material is secured by an adhesive sheet or double-sided tape, peel the adhesive sheet off of the table and store it
in a location free from dust.
Press the
PAUSE/VIEW
key to move the tool carriage to a position where the tool and material can easily be removed.
1
2
3
4
5
6
•
After finishing, be sure to wash the hands with water to remove any adhering cutting chips.
•
Use a vacuum cleaner to remove cutting dust.
Do not use any blower like airbrush. Otherwise, dust spread in the air may harm your health or damage
this machine.
8 Ending Cutting and Plotting Operations
Changes the
r.p.m
knob on the control panel.
Spindle Speed
Cutting and Plotting Speed
Changes the
SPEED
knob on the control panel.
ESCAPE . . . . . . .
Holding down the
PAUSE/VIEW
key for one second or longer causes the tool carriage to move
to the VIEW position and stop.
Press the
PAUSE/VIEW
key a second time to continue cutting and plotting.
STOP . . . . . . .
Press the
PAUSE/VIEW
key to pause operation.
Stop sending data from the computer, then switch off the power to the CAMM SCRIBE.
To restart the cutting and plotting operation from the beginning, switch the power back on, and
send the data from the computer again. (The origin-point setting remains in memory even when
the power is switched off.)
Содержание CAMM SCRIBE CS-20
Страница 26: ...18 Appendix C Specifications...
Страница 28: ...R8 001101 CS 20...
