ROJEK PF 400 S, Инструкция по эксплуатации

Страница: 20 / 35

8.0 Connection to mains
Only a qualified person is allowed to realize the first
connection of the machine to the mains.
8.1 Connecting to mains
Make sure that no voltage is at supply
lead before connecting. Unscrew
the cover of the terminal board (A), put
the connecting cable through - into the
box with the terminal board and
connect individual phase conductors
with corresponding clamps. Connect
the protective conductor (yellow-green)
to the clamp PE and the central con-
ductor (pale blue) to the clamp N, if
required. Crossections of phase
conductors and protective conductor
must be conformable with legal
standard norms. Check up the right-
ness of connecting and fasten
the terminal cover with screws again.
8.2 Safety of operation
Damaged supplying lead must be replaced immediately
by a competent specialist. Machine run on damaged
supply cables is dangerous to life and therefore
forbidden !
Before establishing the machine to the run make sure that the voltage and frequency stated
on the machine rating plate answer to those of supplying network. The mains socket, hereby
the machine is supplied, must be grounded (or neutralized) according to regulations
and safeguarded with at least 16 A fusible cut-out breakers or an L-circuit breaker
Always switch off the main switch and lock it or discon-
nect the machine by towing the plug from the socket
before tools adjusting, replacement and all adjusting,
treatment and maintenance works. Herewith you avoid
eventual machine starting by chance by an else person.