3. Stop the appliance and pull out the power supply plug, then
take out the batteries of remote controller and store appliance
properly.
1.
Clean the air filter and reinstall it.
2.
5. Remove the air hoses and store them properly, and cover the
hole tightly.
The following cases may not always be a malfunction, please check suggestions
below before asking for service.
Does not run
* If the protector trip or fuse is blown.
* Please wait for 3minutes and start again, protector device may be
preventing unit from working.
* If batteries in the remote controller are exhausted.
If the plug is not properly plugged in
Runs for a short while only
* If the set temperature is close to room temperature, you can lower the
set temperature.
* Air outlet is blocked by obstacle. Take the obstacle away.
Runs but not cooling
* If the door or window is open.
*If there is another appliance heat-working like heater or lamp etc.
* The air filter is dirty, please clean it.
* Air outlet or intake is blocked.
* Set temperature is too high.
Water leak during moving
* Drain the condensate before moving.
* To avoid water leakage, please locate the unit on flat ground.
* Pull out the rubber plug to drain water.
* If it
’s often in this state, please contact qualified service technical.
