Remote Control - Commands
R&S NRP
1144.1400.12 6.84
E-3
Operation Sense Status Register
The CONDition register contains information as to whether a sensor is currently being initialized and,
depending on the configuration of the transition register, the EVENt register indicates whether a sensor
initialization was started or completed since the last readout of this register. This status is assumed by a
sensor if one of the following conditions is met:
•
the supply voltage is switched on (power up)
•
the sensor was just connected
•
a reset was performed (
*RST
or
SYSTem:PRESet
)
The Operation Sense Status Register can be read by the following commands:
STATus:OPERation:SENSe[:SUMMary]:CONDition?
STATus:OPERation:SENSe[:SUMMary][:EVENt]?
Table 6-24: Meaning of bits used in the Operation Sense Status Register
Bit
No.
Meaning
0
Not used
1 Sensor
A
initializing
Sensor A is being initialized.
2
Sensor B initializing
Sensor B is being initialized.
3
Sensor C initializing
Sensor C is being initialized.
4
Sensor D initializing
Sensor D is being initialized.
5 to
14
Not used
15
Bit 15 will never be used.
