Rohde & Schwarz 1307.7000.40, Начало работы

Страница: 41 / 58

Preparing for Use
R&S
®
ZVA-Z90E / -Z110E
10 Getting Started 1307.7197.62 ─ 08
Risk of instrument damage
The RF input power at the connectors RF IN and LO IN must not exceed the maximum
values quoted in the data sheet. The maximum values are below the maximum RF
source power of the network analyzer. The frequency converter mode ensures compat-
ible source powers.
Before you connect your converter to the network analyzer, always activate the fre-
quency converter mode using the "Frequency Converter" tab of the "System Configura-
tion" dialog (see
Chapter 3.3, "Activating the Frequency Converter Mode" ,
on page 20) and select the proper converter type and connecting diagram.
2.3.5 RF Connectors – Output
Two SMA connectors:
●
MEAS OUT (measurement signal output)
●
REF OUT (reference signal output)
For correct cabling, please refer to Chapter 2.4.6, "Connecting RF Cables" ,
on page 13.
2.3.6 Control Connector
The three-pin control connector receives the control signal for the source power of the
frequency converter.
For correct connection read Chapter 2.4.5, "Connecting the Control Cable" ,
on page 13.
2.4 Putting the Converter into Operation
This section describes the basic steps to be taken when setting up the frequency con-
verter for the first time.
Putting the Converter into Operation