MobiLink IP
Status indicators
MobilinkIP_Usermanual-sw1.2.21_revGen.doc
Page 74 of 188
Volume
When the feature is active, one can modify the sound level
both for the output – TX and input – RX of the voice
channel. Note that this feature is not available for all types
of modules; some GSM modules do not support this. Select
Volume to change the audio level for
input
and
output.
The
default is -12 dB, you can select to change the volume in 1
dB increments ( from -20 dB up to an amplification of 6 dB).
One may use the "Default" button located at the bottom of the page to restore
the default level for both input and/or output.
Definition of RX and TX
In this page for Mobile Settings, RX is the voice path coming form the mobile network
towards VoIP, while TX is the reciprocal voice path, which comes form VoIP towards the
mobile network.
Note1
: Don’t forget to use the button “
Save
” to store the changes performed over the audio volume.
Note2:
The audio volume can be set up only when the State of the Mobile module is “ready”, which
means registered but not busy.
If the module was busy dialing a number, or sending / receiving SMS messages, it will not be
available for
interrogation
, so the request to set a different audio level will not be applied.
Note3
: Do
not change the audio level parameters unless necessary, as this may affect the voice
quality.
Send/ receive ID
– one may select to
receive
and
send out
or
not the Caller ID (presentation), by means of the fields CLIR and
respectively CLIP.
ID is also called Automatic Number Identification.
CLIR – restrict the sending of identity
O
ne may select to
send out
or not the Caller ID (presentation). When you
choose
Yes
, MobiLink IP will perform
CLIR
- the identity of the call will
not
be
sent (identity restricted).
No
means CLIR is disabled, so ID
will be sent –
the
default setting.
Network
means the sending or not of caller ID is established by the operator
of the mobile network, according to the subscription of your SIM card.
See below an example of call with restricted identity, ANI shows up as “unknown”:
Warning
:
Several services, including routing of calls, rely on the ID of the caller, if you select Yes,
these services may no longer be accessed
.
CLIP - Receiving identity
Yes of No
– the same applies for
receiving
the
calling line identification
presentation.
Note
–
the options concerning CLIP enable or disable sending or receiving of ID
for all the calls performed over the respective Mobile module
