RFT1000 in RACS 5 User Manual.doc
2017-10-05
6/13
In order to ensure this, all GND terminals of various power supply units in the system must be
connected with each other using separate wire. Alternatively, the common negative pole (GND) of
the entire system can be earthed, but only in single point.
3.4 Inputs
RFT1000 reader is equipped with two (IN1, IN2) inputs which can be configured as NO/NC with
RogerVDM software. Inputs can be assigned with functions using RogerVDM software and VISO
software where they are operated in the same way as any other inputs of controller or peripheral
devices. The configuration and application of inputs is optional.
3.5 Wall mounting
Fig. 4 RFT1000 installation
3.6 Use/installation guidelines
All electric cables must be connected to devices with disconnected power supply.
If the range of card reading is significantly lower than specified in technical documentation then
consider relocation of reader.
After installation of RFT1000 reader, remove protector from fingerprint scanner. Otherwise it
may hinder fingerprint scanning.
In case of connection through Ethernet port, twisted pair cable should be uninsulated in the
shortest possible distance and wires should remain twisted in the longest possible distance.
It is required to install proximity card readers in minimal distance of 0.5m from each other.
In order to ensure correct operation of the reader it is necessary to clean fingerprint scanner
regularly by means of wet cloth and mild detergent. Do not clean by means of abrasive
materials and strong cleaners like alcohols, solvents, etc. Damages to scanner surface are
beyond the scope of warranty.
RFT1000 reader should be installed in shaded and dry place, far from heat and moisture. It is
necessary to avoid dust and abrupt temperature changes. The reader cannot be installed in
places exposed to direct sunlight. In the event of exposure of the device to direct sunlight or
strong artificial light it may operate improperly.
Proper finger placing for the purpose of fingerprint reading is shown in fig. 5. In case of kids
(small fingerprints) it is recommended to verify fingerprint reading prior to installation of
RFT1000.
