WM-020-369-10-en
BA SPEEDY classic 2 balance
.doc
STARK Spannsysteme GmbH – Roemergrund 14 - 6830 Rankweil - Austria
Tel.:+43 5522 37400-0 - Fax.:+43 5522 37400-700 - e-mail:
-
www.stark-inc.com
13/16
8.4 General cleaning
Dismantle the fast closing clamp to carry out general cleaning.
In principle, only an authorised service engineer may carry out installation work on fast closing
clamps. During all work make sure of compliance with the necessary safety measures without
exception and in their entirety.
Hazard warning:
The fast closing clamp is permanently under spring pressure. Never undo the
screws on the fast closing clamp!
Damage to parts!
Insertion with nipple into the elements must be less than 100 mm/s, otherwise it could lead to
damage to the nipple and elements.
Do not clean the product with:
• Corrosive or caustic ingredients or
• Organic solvents such as halogenated or aromatic hydrocarbons and ketones (thinners,
acetone etc.), as these substances can irreparably damage the seals.
The element must be cleaned at regular intervals. During this process, clean especially the piston and
housing of swarf or other liquids.
In case of heavy soiling the cleaning must be carried out at shorter intervals.
Lubricants and oils (hydraulic oil)
U
nsuitable lubricants and oils may damage the seals and severely impair their service life.
ATTENTION:
Do not mix oils.
Recommendation:
: "Castrol Hyspin AWS 32" or "Castrol Hyspin AWS 46" hydraulic oil
Replace cup springs
After the maximum number of clamping cycles is reached, change the cup springs (see Chapter 9
"Specifications“ Maximum number of clamping cycles of fast closing clamps).
8.5 Storage:
Before first-time use:
If you do not use the fast closing clamp immediately, please store it in the original packaging dry and
dust-free.
Extended storage after usage:
