S-8600 UHF RFID Reader User Manual
UHF RFID User Manual
25
2.6.4 Setting Buzzer Status
Sound of the reader’s working status provided to users through the Buzzer.
Users can turn off the buzzer or set it “beep” after each time reader inventory tag.
You can also set it “beep” afer each time reader identifies a tag. But this will reduce the
efficiency of multi-tag identification.
Operation interface as below:
Note: The Buzzer will ring when Power On Self Test successfully and it is not controlled
by this setting.
After setting completes, the state of buzzer will be saved in the FLASH inside of reader
and won’t lose after power cut.
2.6.5 Charging The Serial Communication Baud Rate
Reader supports two kinds of baud rate: 38400 bps and 115200 bps.
You can set baud rate via the interface as below:
After setting successfully, new baud rate will be saved in the FLASH inside of reader
and won’t lose after power cut. But the baud rate communicate with the reader must be
new.
Note:
◆
If you use the TCP/IP interface, please change the serial rate of TCP/IP module into
corresponding. Details see the supplied TCP/IP interface configuration document.
◆
Inventorying Tags under
Real Time Model
will produce large amounts of data, please
try to use 115200 baud rate.
