Rodia DC 1450TS, Руководство по эксплуатации

Страница: 26 / 39

19
RODIA
®
DC 1450TS
GB
Subject to change without notice.
Zevenbergen, November 2014
R.G.W. van den Boogaart
General Manager
For spare parts or advice contact
Rodiam b.v.
Postbus 58
NL - 4760 AB Zevenbergen
+31(0)168 331 320
info@rodiam.nl
troubleshootIng
Problem Cause Solution
The machine
doesn’t start.
The power supply cable is
damaged or not properly con-
nected.
No voltage in the power outlet.
Start switch is damaged.
Press the plug firmly in the power
outlet. Check the power supply
cable.
Have the power outlet checked.
Have the switch replaced.
Motor isn’t running
smoothly.
Water may have seeped
through inside the motor.
Capacitor is damaged.
Damaged motor bearing.
Unplug the power cable and
consult your local dealer.
Cutting out of align-
ment.
Machine is not leveled out.
Unstable working surface.
Improper or glazed diamond
blade.
Loosen the screws for the legs.
Pick up the machine a little bit on
one end. Let the machine down
again and tighten screws. Per-
form the same procedure on the
other end. The machine should
now be leveled out.
Make sure the machine is placed
on a leveled surface.
Replace or dress the diamond
blade.
declArAtIon of
conformIty
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization
documents.
98/392/EEC, 91/368/EEC,
93/44/EEC, 93/68/EEC,
89/336/EEC, 92/31/EEC,
73/23/EEC
09