Rodgers W-5000, Руководство пользователя

Страница: 126 / 165

Chapter 10
126
Detune
This parameter makes detune settings; a setting which raises or lowers the pitch in very small increments
(cents; 1/100th of a semitone). Detuning one Tone in a layer can create a 'fatter', chorus-like effect. Positive
numbers increase the pitch above the normal pitch of the sound. Use the [+] and [-] buttons.
Hz Detune
This parameter makes another kind of detune setting (in 0.2 Hertz steps). Use the [+] and [-] buttons.
(Positive numbers raise the pitch above the normal pitch of the sound.)
Vel Sense
This parameter sets the velocity sensitivity. Higher numbers will allow you to produce louder sounds without
having to increase your playing strength. Use the [+] and [-] buttons. (A value of '-10' makes the sound
completely insensitve to velocity. This value, coupled with a 'Vel Offset' setting allows you to set a constant
velocity level.)
Vel Offset
This parameter sets the velocity offset; the minimum velocity level. Use the [+] and [-] buttons.
Glide Time
This parameter sets the glide (portamento) time. Use the [+] and [-] buttons.
Vib Delay
This parameter sets the vibrato delay, the time it takes for the vibrato sound to be heard after a note is played.
Use the [+] and [-] buttons.
Sustain
This parameter turns the sustain effect (which causes a note to appear to still be held after it has been
released) on and off. Use the [+] and [-] buttons.
Sostenuto
This parameter turns the sostenuto effect on and off. Sostenuto is an effect which sustains only notes that are
held when the effect is activated. This allows you to sustain a chord and then play a non-sustained melody.
Use the [+] and [-] buttons.
Soft
This parameter turns the soft effect on and off. This is an effect which makes the notes played sound
somewhat softer. Use the [+] and [-] buttons.
Glide
This parameter adds an offset (additional) value to the depth value set in the [CONTROLS] menu. Use the
[+] and [-] buttons.
Rotary S/F
This parameter turns the rotary S/F effect on and off. Use the [+] and [-] buttons. (This parameter works
regardless of the settings of the Keyboard or Layer fields found under the [CONTROLS] button.)