Rodgers Trillium T807, Руководство пользователя

Страница: 21 / 67

12
The Crescendo must be unlocked to set a Crescendo sequence. Once the sequence is set, it may
be locked again to prevent accidental change.
Unlocking Crescendo
1. Press and hold the ALL SWELLS piston for approximately five seconds until CRESCENDO
LOCKED appears in the display.
2. While continuing to hold ALL SWELLS, rotate the Alpha dial in either direction until the
display reads CRESCENDO UNLOCKED.
3. Release the ALL SWELLS piston. The Crescendo is unlocked.
Setting Crescendo Sequence
1. Press and hold the SET piston.
2. Press the ALL SWELLS piston. The piston flashes, and the display shows:
C r e s c e n d o S e t
C r e s c e n d o S e t
S T A G E :
M o d e S T D
1
The stops and couplers currently set on stage one of the 63 stages in the Crescendo sequence
turn on.
3. The current sequence may be viewed by advancing through the stages one at a time using the
Alpha dial. At each stage, the stage number (1 to 63) is indicated in the Console Display, and
the stops and couplers set at this stage turn on.
4. To add one or more stops to the sequence, go to the stage where the stop(s) is to be added,
turn the stop(s) on, and press SET.
5. To delete a stop(s), go to the first stage in which the stop(s) turns on, turn the stop(s) off, and
press SET.
6. Each stop can be turned on at any stage and turned off at any later stage. As an example,
assume the SWELL 8' BOURDON is to turn on at stage 1 and off at stage 25. Go to stage 1,
turn on the SWELL 8' BOURDON, and press SET. Then go to stage 25, turn off the SWELL
8' BOURDON, and press SET.
7. To clear the entire Crescendo sequence (stages 1 through 63), hold SET and press General
Cancel. This also resets the current stage number to 1 so that a new sequence can be entered.
8. When building a completely new sequence, it is advisable to first write the new sequence
down, then assign stage numbers from 1 to 63 to each stop or group of stops in the sequence.
Sometimes there are more stages than stops in the sequence, so it is necessary to skip some
stages to make the sequence end at or near stage 63. If this is not done, the sequence ends
before the Crescendo shoe is fully depressed.