Rodgers Trillium T787, Руководство пользователя

Страница: 87 / 100

76
2. Start the sequencer in Record mode.
3. Wait until sequencer is recording (after the count-in measures, if any) then hold
SET and momentarily press the memory piston ( M1 , M2 , M3 or M4 )
corresponding to the memory you wish to store.
4. Release both pistons. The console display will read:
M e m o r y C o p i e d
T o S e q u e n c e r P o r t
11. Wait five seconds, then perform steps 3 and 4 above to send another memory to
the sequencer, if desired. Make certain you leave a few measures of space
between the memories which are saved.
12. When all memories have been recorded, stop the sequencer.
Remember to save the sequence after all memories have been recorded.
Restoring a Combination Memory
To restore a memory which has been saved to a sequencer:
1. Make certain sequencer is connected correctly to the SEQ IN and SEQ OUT
jacks.
2. Begin playback of the sequence containing the piston information.
3. Stop the sequencer as soon as a memory piston ( M1 , M2 , M3 or M4 ) begins to
flash. This indicates that a memory has been received by the organ. (The
particular memory piston which flashes denotes which memory level has been
received from the sequencer).
4. Hold SET and press the memory piston where you’d like the memory stored.
This selection can be any of the available memory pistons.
5. Release both pistons. The memory will be saved.
6. If more memories exist in the sequencer recording (and you want to write them
into the instrument) press Play to start the sequencer from that point and then
follow steps 3 through 5 again.