Trouble-shooting
Headlights don’t work correctly speed step mode of the Lokmaus®2 and the loco-decoder don’t
flashes or can’t be switched on match. The speed step mode for the address of the loco at the
or off
Lokmaus®2 is wrong or the CV29 is programmed faulty.
How to define the speed step mode see page 23
How to program the CV29 you find on page 25
loco doesn’t move
speed step mode of the Lokmaus®2 and the loco-decoder don’t
(128 speed step mode)
match. The speed step mode for the address of the loco at the
Lokmaus®2 is wrong or the decoder desn’t support this mode.
How to define the speed step mode see page 23
How to program the CV29 you find on page 25
sense of driving of the loco is the programming of the CV29 must be corrected to change the
inversed
sense of driving.
How to program the CV29 you read on page 25
headlights of the pilot car (e.g. By programming the CV29 you must change the sense of driving
of the ICE don’t match direction of the pilot car. Put the pilot car without loco on the programming track!
How to program the CV29 you read on page 25
the speed step mode can’t be knob is not in middle position (00). In this position you can control
changed
the speed step mode, but you can’t change it.
How to change the speed step mode you can read on page 23.
the display shows the
an other Lokmaus®2 in the system is programming. You can pro-
message ‘PA’
gram only by one Lokmaus®2 simultaneously. During this time no ot-
her Lokmaus®2 can make an input. If the programming procedure is fi-
nished, this message disappears automatically and the locos re-start
to run.
31
