4
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
BURSTING HAZARD!
• Do not exceed 90 psi (6.2 bar) of tool inlet pressure. Permanent tool
damage and/or bursting could occur and cause personal injury.
INJURY HAZARD!
• This tool has high-speed, abrasive surfaces which can quickly cause injury.
Keep fingers and hands away from moving parts when operating. Wear
thick, well-fitting work gloves and keep loose clothing, sleeves, cords,
jewelry and hair away from moving parts.
• This tool can eject sparks which can ignite flammable materials. Do not
operate near flammable materials and keep all persons and pets away
from the work area.
• Always make sure the workpiece is securely clamped or anchored to avoid
sudden movements which could result in injury.
• Always disconnect tool from air supply when changing Abrasive Belts
or making adjustments to prevent accidental tool starting and potential
severe injury.
• Frequently inspect Abrasive Belt and tool condition. If cracks develop,
discontinue tool use immediately and replace damaged pad. ONLY USE
replacement Abrasive Belts rated for 18,000 RPM or greater otherwise
severe injury can result in the event of Belt failure.
VIBRATION INJURY HAZARD!
• This tool will vibrate during use! Repeated exposure to vibration may cause
physical injury.
SET UP & CONNECTION
• Wrap white thread sealing tape (not included) around the threads of the included
1/4” Male NPT quick disconnect fitting then thread it into the 1/4” NPT inlet threads
of the Belt Sander Body.
• Attach Air Supply to Inlet Fitting.
Be sure that the air supply to the tool is clean and dry. Moisture in the supply
line will quickly damage the air motor and valves.
A minimum 3/8” I.D. air line should be used for optimal performance.
