6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
ADJUSTING SANDING ARM ANGLE
• Disconnect air supply from the tool to prevent
accidental starting and potential injury while
adjusting the Abrasive Belt Arm Angle.
• Using the included 4mm Hex Key, loosen the
Angle Adjusting Screw located on the upper side
of the Abrasive Arm Assembly
(FIG 4)
, rotate
Arm to desired position then tighten screw
securely.
ADJUSTING BELT TRACKING
• Disconnect air supply from the tool to prevent
accidental starting and potential injury while
adjusting the Abrasive Belt Tracking. The Track-
ing Adjustment Screw is located at the outer right
side of the Abrasive Arm Assembly
(FIG 5)
.
• Using a Phillips screwdriver, turning the screw
clockwise (as viewed from the right side) will
cause the belt to track left while turning the
screw counter-clockwise will cause the belt to
track right.
MAINTENANCE
• Before each use, add a few drops of a quality air tool oil (not included).
• If tool is to be unused for an extended period, add 10 drops of air tool oil directly to the air inlet
then store the tool, inlet up.
• With the air supply disconnected, periodically check that the belt is not worn, torn and is tight.
FIG. 4
Rotate Arm
FIG. 5
INJURY HAZARD!
Disconnect air supply from the tool to prevent accidental starting and
potential injury while installing or removing Abrasive Belts.
INJURY HAZARD!
Disconnect air supply from the tool to prevent accidental starting and
potential injury while adjusting Belt Tracking.