Rockwell ShopSeries RK7032, Руководство пользователя

Страница: 10 / 32

DRILL PRESS ENG
10
SyMbOLS
Read the manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
n
o
No load speed
TEChNICaL DaTa
Voltage:
Amps:
No load speed:
Swing:
Chuck capacity:
Spindle travel:
Table size:
Throat depth:
Table bevel range:
Speed n
o
.:
Weight:
OPERaTING INSTRuCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WaRNING! To prevent personal injury, do not
connect the machine to the power source until
the machine is completely assembled and you have
read and understand the entire instruction manual.
Always disconnect the plug from the power source
before assembling parts, making adjustments or
changing drill bits.
aSSEMbLy
1. aSSEMbLy OF MaChINE baSE/COLuMN
1) Position machine base on floor (See A)
Remove protective sleeve from column tube and
discard. Place column assembly onto machine base,
and align holes in column support with holes in base.
Install a bolt in each hole (through column support and
base) and tighten the fixing bolts (8) with adjustable
wrench.
2) Locate the elevation worm gear (a) (in loose parts
bag) and the table crank. Insert the shaft of the elevation
worm gear into the table support bracket (b) and extend
the shaft through the opening as far as possible. Attach
the table crank to the shaft with the set-screw (c). The
set-screw is to be aligned with the flat portion of the
shaft. The table crank is to be positioned as close to
the arm support as possible, then tighten the set-screw
with the hex wrench. Do not over-tighten the set-screw.
(See B)
3) Remove collar from the column. With the long smooth
end of the raising rack (d) pointing upward, slide the
120V-60Hz
3.6A
830-3300rpm
10˝
1/2˝
2-3/8˝
8˝ x 7-1/2˝
4-15/16˝
0-45
o
Left & Right
5
79lbs